How to enable UPNP

Using UPNP ( Universal Plug and Play )

UPNP, if it works, allows you to set up remote access automatically with your router. This guide assumes you have already set up the network and you know how to access the login page for the recorder.

Click here for more information on setting up your recorder's network parameters.

Click here for more information on accessing your recorder through the browser.

Enabling UPNP

Step 1. Log into your recorder on the browser.

Step 2. Click on "configuration"

Step 3. Click on "network"

Step 4. Click on "NAT"

Step 5. Check "Enable UPnP" and make sure port mapping mode is set to automatic.

Step 6. Select "Save" to save and apply your settings.

Step 7. Refresh the page and you should now see changes in both the external port and IP address for each port type.

Step 8. For remote access, you will only use the external port and IP address shown to you. 

Note: This method is not guaranteed to work every time.